Start practice — 8 questions →
Sample questions
Before discharging effluent containing XT 2000 into sewer systems, what action must be taken?
- Notify the local sewage treatment plant authority
- Dilute with water by a ratio of 10:1
- Test the pH level of the effluent
- Wait 24 hours for the product to settle
Show answer
The label states not to discharge effluent to sewer systems without previously notifying the local sewage treatment plant authority.🔗 Source
Which target pest is XT 2000 specifically indicated to control via the described application method?
- Structural Drywood Termite
- Subterranean Termite
- Carpenter Ant
- Formosan Termite
Show answer
The label facts explicitly list Structural Drywood Termite as the target pest.🔗 Source
What is the maximum duration recommended for injecting the product into drilled holes?
- Up to one minute
- Up to thirty seconds
- Up to five minutes
- Up to ten minutes
Show answer
The label instructions specify to inject for up to one minute.🔗 Source
When applying XT 2000 to infested wood, what is the recommended pattern and spacing for drilling holes?
- A 'W' pattern at 3"-5" intervals
- A straight line at 1"-2" intervals
- A circular pattern at 5"-10" intervals
- A grid pattern at 4"-6" intervals
Show answer
The label instructions state to use a 'W' pattern at 3"-5" intervals.🔗 Source
Which of the following is a required component of the PPE for all pesticide handlers using XT 2000?
- Long-sleeved coveralls worn over a minimum of short-sleeved shirt and short pants
- Full-body Tyvek suit with integrated hood
- Rubber apron and heavy-duty boots
- N95 respirator and chemical goggles
Show answer
The PPE section requires long-sleeved coveralls worn over a minimum of a short-sleeved shirt and short pants.🔗 Source
According to the label restrictions, what must a technician avoid when drilling into wood for treatment?
- Electrical wiring and plumbing
- Painted surfaces
- Hardwood species
- Structural beams
Show answer
The label explicitly states to avoid electrical wiring and plumbing when drilling.🔗 Source
What is the restriction regarding reapplication of XT 2000 to the same area?
- Do not reapply again to same area within one year
- Do not reapply to same area within 30 days
- Do not reapply to same area within 6 months
- Do not reapply to same area within 2 years
Show answer
The label restrictions state: 'Do not reapply again to same area within one year.'🔗 Source
When drilling holes into 'kick-outs' to intersect galleries, what size drill bit should be used?
Show answer
The label instructions specify to drill 7/64" holes into 'kick-outs'.🔗 Source
← All practice exams