Start practice — 8 questions →
Sample questions
Which type of glove material is specifically required by the PPE section of the label?
- Barrier laminate or Viton
- Latex or Nitrile
- Leather or Canvas
- Rubber or Neoprene
Show answer
The PPE section requires chemical-resistant gloves specifically made of barrier laminate or Viton.🔗 Source
Under which weather condition is application of Silencer prohibited?
- Wind velocity exceeding 15 mph
- Temperatures below 40 degrees
- Humidity exceeding 80%
- Cloudy or overcast skies
Show answer
The timing/weather instructions state: Do not apply if wind velocity exceeds 15 mph.🔗 Source
When mixing Silencer, what is the correct procedure for filling the spray tank?
- Fill tank at least one-third full of clean water or diluent, add product, then add remaining water/diluent.
- Fill tank completely with water, then add product to the top.
- Mix product with non-emulsifiable oils first, then add to the tank.
- Fill tank halfway with diluent, add product, then add the remaining half of the water.
Show answer
The mixing notes state to fill the tank at least one-third full of clean water or diluent, add product, and then add the remaining water/diluent.🔗 Source
What is the Re-entry Interval (REI) for Silencer?
- 24 hours
- 12 hours
- 48 hours
- 72 hours
Show answer
The label lists the REI as 24 hours.🔗 Source
To prevent harm to non-target organisms, when should you avoid applying Silencer?
- When bees are actively visiting the treated area
- When the sun is at its highest point
- When the soil is completely dry
- When the temperature is above 90 degrees
Show answer
The label states to avoid application when bees are actively visiting the treated area because it is highly toxic to bees.🔗 Source
According to the label, what is the application rate for Silencer when managing cutworms in orchard and vine crops?
- 50 gallons of finished spray per acre
- 10 gallons of finished spray per acre
- 12.7 gallons of finished spray per acre
- 15 gallons of finished spray per acre
Show answer
The label specifies a rate of 50 gallons of finished spray per acre for orchard and vine crops.🔗 Source
Which of the following is a permitted method of application for Silencer?
- Sprinkler irrigation systems
- Indoor fogging
- Direct water application
- Non-emulsifiable oil dilution
Show answer
The label states the product can be applied through sprinkler irrigation systems.🔗 Source
Which of these is a restriction regarding the use of diluents with Silencer?
- Do not use non-emulsifiable oils as diluents.
- Only use distilled water as a diluent.
- Diluents must be at least 12.7% concentration.
- Do not use any diluent other than clean water.
Show answer
The restrictions section explicitly states: Do not use non-emulsifiable oils as diluents.🔗 Source
← All practice exams