Start practice — 8 questions →
Sample questions
Under what wind conditions should you avoid applying Savate 2026 03 22?
- Winds greater than 5 mph
- Winds greater than 10 mph
- Winds greater than 15 mph
- Winds greater than 20 mph
Show answer
The label instructs: 'Do not apply when winds are greater than 15 mph and avoid gusty conditions.'🔗 Source
According to the label, Savate 2026 03 22 should NOT be used on which of the following?
- Marigolds
- Verbena
- Vegetable gardens
- Snapdragons
Show answer
The restrictions state: 'Do not use on vegetable gardens.'🔗 Source
According to the label, which of the following sites is an approved application site for Savate 2026 03 22?
- Geraniums
- Lantana
- Peperomia
- Dracaena
Show answer
Lantana is listed as an approved site, while geraniums, Peperomia, and Dracaena are specifically prohibited.🔗 Source
What is the maximum allowable application rate for Savate 2026 03 22 per single application?
- 4 fl oz per 100 gal
- 1 fl oz per 100 gal
- 2 fl oz per 100 gal
- 2 fl oz per 50 gal
Show answer
The label states do not apply more than 2 fl oz per 100 gal per application.🔗 Source
To prevent runoff into water bodies, how much time must pass between product application and any irrigation that results in surface water runoff?
- 12 hours
- 24 hours
- 48 hours
- 72 hours
Show answer
The label requires allowing at least 24 hours between application and irrigation resulting in surface water runoff into specified water bodies.🔗 Source
When mixing Savate 2026 03 22, at what stage should the Savate and other 'flowable' (FL or SC) products be added to the tank?
- First, before any water is added
- After the tank is filled to the desired level
- After adding any wettable powder (WP) or wettable granules (WG) products
- Immediately after filling the tank 1/4 to 1/3 full with water
Show answer
The mixing instructions state to add WP or WG products first, then add Savate and flowable products.🔗 Source
Which of the following is a prohibited method of application for Savate 2026 03 22?
- Manual spray application
- Through irrigation systems
- Using an agitator
- Recirculating while mixing
Show answer
The restrictions explicitly state: 'Do not use through irrigation systems.'🔗 Source
What is the maximum total amount of Savate 2026 03 22 that can be applied during a single cropping cycle?
- 2 fl oz
- 4 fl oz
- 6 fl oz
- 8 fl oz
Show answer
The label specifies not to apply more than 4 fl oz per cropping cycle.🔗 Source
← All practice exams