Start practice — 8 questions →
Sample questions
To achieve a 0.10% finished strength for subterranean termites, how much product should be mixed with 100 gallons of water?
- 12.5 fl. oz.
- 25 fl. oz.
- 50 fl. oz.
- 6.3 fl. oz.
Show answer
The mixing instructions state that 25 fl. oz. of product in 100 gallons of water results in a 0.10% finished strength.🔗 Source
When treating soil for subterranean termites, what dilution should be used for typical control situations?
- 0.05% to 0.1%
- 0.1% to 0.2%
- 0.01% to 0.05%
- 0.5% to 1.0%
Show answer
The label states that a 0.05% dilution is generally used for typical control situations, within the 0.05% to 0.1% range.🔗 Source
When treating voids in hollow masonry units, how should the solution be applied?
- By spraying the exterior surface only
- By injecting into the lower areas of the wall, just above the floor or footing
- By flooding the entire foundation perimeter
- By applying 4 gallons per 10 linear feet
Show answer
The label notes for voids in hollow masonry units specify applying the solution so it reaches the footing by injecting into the lower areas of the wall.🔗 Source
What is the maximum allowable pressure for the treatment tool when using a low pressure spray for foundation perimeter treatment?
- 12 inches
- 25 PSI
- 6 inches
- 0.1%
Show answer
The label instructions for foundation perimeter trenching/rodding state to use a low pressure spray not to exceed 25 PSI.🔗 Source
When performing foundation perimeter trenching, what are the recommended dimensions for the trench?
- 4 inches wide and 4 inches deep
- 6 inches wide and 6 inches deep
- 12 inches wide and 12 inches deep
- 2 inches wide and 6 inches deep
Show answer
The label specifies that when trenching, the trench along the outside foundation should be about 6 inches in width and 6 inches in depth.🔗 Source
Which of the following is a stated restriction for this product?
- Do not apply near water sources
- Do not apply during rain
- Do not formulate this product into other end-use products
- Do not apply to masonry units
Show answer
The restrictions section explicitly states: 'Do not formulate this product into other end-use products.'🔗 Source
According to the label, what is the primary target pest for the application methods listed?
- Ants
- Subterranean termite
- Cockroaches
- Fleas
Show answer
The label facts specifically list subterranean termite as the target pest for all provided application scenarios.🔗 Source
If the fill under a slab consists of gravel or other coarse aggregate, what is the required application rate for subterranean termites in the soil?
- 1 gallon per 10 square feet
- 2 gallons per 10 square feet
- 1.5 gallons per 10 square feet
- 4 gallons per 10 linear feet
Show answer
For soil where fill under the slab is gravel or coarse aggregate, the rate is 1.5 gallons per 10 square feet.🔗 Source
← All practice exams