Start practice — 8 questions →
Sample questions
Which of the following pests is specifically listed as being suppressed by the foliar application method?
- Black Vine Weevil Larvae
- Thrips
- Emerald Ash Borers
- White grub larvae
Show answer
The label lists thrips (suppression) under the foliar application target pests.🔗 Source
Which pest group is included in the target list for soil application but NOT listed for foliar application?
- Aphids
- Japanese beetles
- Black Vine Weevil Larvae
- Whiteflies
Show answer
Black Vine Weevil Larvae is listed under soil application targets but is absent from the foliar application target list.🔗 Source
To treat approximately 1,000 sq. ft. via soil application, what is the required amount of product and dilution?
- 3.0 fl. oz. per 1 gallon of water
- 6.0 fl. oz. per 2 gallons of water
- 9.0 fl. oz. per 3 gallons of water
- 12.0 fl. oz. per 4 gallons of water
Show answer
The label specifies 9.0 fl. oz. per three (3) gallons of water for treating approximately 1,000 sq. ft.🔗 Source
What is the recommended interval between repeat applications if high pest pressure is observed?
- 5-7 days
- 10-14 days
- 21-28 days
- Once every 30 days
Show answer
The label advises repeat applications with 10-14 day intervals between applications.🔗 Source
According to the label, where should the product be applied for 'Established plantings'?
- Directly onto the leaf undersides
- As a broadcast treatment to the seedbed
- To the root zone of the established plants
- To the stems and branches only
Show answer
For established plantings, the label says to apply the drench to the root zone of the established plants.🔗 Source
What must be done after applying the Ferti lome Tree & Shrub Drench to the soil?
- Wait 24 hours before watering
- Irrigate the treated area (0.5 inch) thoroughly
- Apply a foliar spray immediately after
- Mulch the area to prevent evaporation
Show answer
The label instructions state to 'Irrigate the treated area (0.5 inch) thoroughly after the application'.🔗 Source
When using a Hose-End Sprayer for foliar applications, what instruction is provided regarding the jar?
- Fill the jar halfway with water
- Do not add water to jar
- Mix 1 tsp per gallon in the jar
- Add water until the dial reaches 1.5
Show answer
For the Hose-End Sprayer dial setting for foliar pests, the notes state 'Do not add water to jar.'🔗 Source
When performing a foliar application, what is the recommended timing regarding plant flowers?
- During full bloom to ensure coverage
- Only when flowers are in the budding stage
- Prior to blooming or after all flower petals have fallen off
- Immediately after the first bloom cycle ends
Show answer
The label states to make the application prior to blooming or after all flower petals have fallen off.🔗 Source
← All practice exams