Start practice — 8 questions →
Sample questions
Which of the following pest groups is Enlite designed to control in soybean crops?
- Annual grasses, broadleaf weeds, and certain perennials like morningglory
- Only annual grasses and specific perennial weeds
- Insects and fungal pathogens affecting soybean leaves
- Only broadleaf weeds and morningglory
Show answer
The label states Enlite controls annual grasses, broadleaf weeds, and certain perennial weeds such as morningglory and field bindweed.🔗 Source
Which of the following is a specific geographic restriction for the use of Enlite?
- Do not apply in the state of New York
- Do not apply in the state of California
- Do not apply in the state of Texas
- Do not apply in the state of Florida
Show answer
The label explicitly states: 'Do not apply in the state of New York.'🔗 Source
According to the label, where is Enlite intended to be applied?
- Outdoor soybean fields
- Indoor greenhouse soybean crops
- Hydroponic soybean systems
- Only in the state of New York
Show answer
The label identifies the location as outdoor soybean fields.🔗 Source
When tank mixing Enlite with other herbicides, what action is required by the label?
- Perform a jar test for compatibility
- Always mix with metsulfuron and chlorimuron-ethyl
- Dilute with water twice the standard amount
- Only mix with liquid formulations
Show answer
The label notes that when tank mixing with certain herbicides, a jar test for compatibility must be performed.🔗 Source
Which set of Personal Protective Equipment (PPE) is required for handlers of Enlite?
- Long-sleeved shirt, long pants, chemical-resistant gloves, and shoes plus socks
- Short-sleeved shirt, long pants, and rubber boots
- Long-sleeved shirt, chemical goggles, and gloves
- Full body suit, respirator, and chemical-resistant gloves
Show answer
The PPE requirements listed are long-sleeved shirt, long pants, chemical-resistant gloves, and shoes plus socks.🔗 Source
What is the recommended application rate for Enlite per acre?
- 2.8 to 4.25 ounces per acre
- 4.25 to 6.0 ounces per acre
- 1.5 to 3.0 ounces per acre
- 2.8 to 4.25 pounds per acre
Show answer
The application rate specified in the label is 2.8 to 4.25 ounces per acre.🔗 Source
Under which weather conditions should application of Enlite be avoided?
- High winds exceeding 10 mph and temperature inversions
- Rainfall exceeding 0.5 inches
- Temperatures below 40 degrees Fahrenheit
- Humidity levels above 80%
Show answer
The label instructs users to avoid application during high winds exceeding 10 mph and during temperature inversions.🔗 Source
What is the Re-entry Interval (REI) for Enlite?
- 14 days
- 24 hours
- 7 days
- 48 hours
Show answer
The label specifies a re-entry interval (REI) of 14 days.🔗 Source
← All practice exams