Start practice — 8 questions →
Sample questions
When applying Duracor Herbicide at a rate of 20 fl oz/A, what is one of the listed amounts to be used per 3 gallons of water?
- 1.2 fl oz
- 3.0 fl oz
- 0.4 fl oz
- 1.8 fl oz
Show answer
The mixing notes state that at a 20 fl oz/A rate, 3.0 fl oz can be used per 3 gallons of water to achieve a 0.78% finished strength.🔗 Source
What must a technician do before tank mixing any pesticide product with Duracor Herbicide?
- Test the pH of the water
- Refer to www.DuraCorTankmix.com for specific product information
- Add a surfactant to the mixture
- Wait 24 hours after mixing
Show answer
The restrictions state: 'DO NOT TANK MIX ANY PESTICIDE PRODUCT WITH THIS PRODUCT without first referring to the following website for the specific product: www.DuraCorTankmix.com.'🔗 Source
When tank mixing, which of the following is a requirement for the products used?
- They must be liquid-only formulations
- They must be registered for the intended use site, application method, and timing
- They must be applied at the same time of day
- They must contain the same active ingredient
Show answer
The restrictions state that tank mix products must be registered for the intended use site, application method, and timing.🔗 Source
Under which environmental conditions might the herbicide activity be enhanced?
- High rainfall and high humidity
- Adverse conditions such as high temperature, low relative humidity, or drought
- Low temperatures and heavy frost
- Overcast skies and high soil moisture
Show answer
The timing/weather section notes the product can enhance activity under adverse environmental conditions like high temperature, low relative humidity, and drought.🔗 Source
At a 100 fl oz/A rate, what is the finished strength if 0.4 fl oz is used per 3 gallons of water?
Show answer
The mixing notes state that at a 100 fl oz/A rate, using 0.4 fl oz per 3 gallons of water results in a 0.10% finished strength.🔗 Source
According to the label, what are the target pests for Duracor Herbicide?
- Insects and mites
- Weeds and brush
- Fungi and mold
- Rodents and grasses
Show answer
The applications section identifies the target pests as weeds and brush.🔗 Source
If applying Duracor Herbicide at a rate of 16 fl oz/A, how much product should be used per 1000 sq. ft?
Show answer
The mixing notes specify that at a 16 fl oz/acre rate, the amount is 0.37 per 1000 sq. ft.🔗 Source
Which application system is specifically prohibited for use with this product?
- High-pressure sprayers
- Mist blower systems that deliver very fine spray droplets
- Drip irrigation systems
- Handheld pump sprayers
Show answer
The restrictions section states: 'Do not apply this product with mist blower systems that deliver very fine spray droplets.'🔗 Source
← All practice exams