Start practice — 8 questions →
Sample questions
To ensure optimum effectiveness, how much rainfall or irrigation is recommended to activate the product?
- At least 1/4 inch
- At least 1/2 inch or more
- Exactly 1 inch
- At least 2 inches
Show answer
The label states the product is most effective when activated by 1/2 inch or more of rainfall or irrigation.🔗 Source
What is the required Personal Protective Equipment (PPE) instruction regarding treated areas?
- Wear a respirator at all times during application
- Keep unprotected persons out of treated area until sprays have dried
- Wear chemical-resistant gloves during re-entry
- Apply only when wearing full-body Tyvek suits
Show answer
The PPE section states to keep unprotected persons out of the treated area until sprays have dried.🔗 Source
Which of the following best describes the target pests for Dimension Ultra 40WP?
- Crabgrass and other annual grasses and broadleaf weeds
- Perennial grasses and woody shrubs
- Only crabgrass in late stages of growth
- Insects and fungal pathogens in turf
Show answer
The label states the product targets crabgrass and other annual grasses and broadleaf weeds.🔗 Source
What is a critical restriction regarding the application method of this product?
- Do not apply via any type of irrigation system (chemigation)
- Do not apply during daylight hours
- Do not apply using a backpack sprayer
- Do not apply if wind speeds are above 5 mph
Show answer
The restrictions section explicitly states: 'Chemigation: Do not apply this product through any type of irrigation system.'🔗 Source
When using liquid fertilizer as a carrier, what must be done first?
- Add the fertilizer to the tank before the herbicide
- Determine compatibility by mixing small proportional quantities in advance
- Dilute the fertilizer with 1/2 inch of water first
- Ensure the fertilizer is a dry powder only
Show answer
The label instructs to first determine compatibility by mixing small proportional quantities in advance.🔗 Source
Regarding the timing of application for optimal weed control, when should Dimension Ultra 40WP be applied?
- Preemergence (prior to germination of target weeds)
- After weeds have reached full maturity
- Only during the dormant season
- After the first heavy frost
Show answer
The label notes that for optimum control, applications should be made preemergence, prior to germination of target weeds.🔗 Source
When mixing Dimension Ultra 40WP alone with water, how long should you wait after adding the unopened packets before turning on the agitation?
- Immediately after adding packets
- 30 to 45 minutes
- 5 to 10 minutes
- At least 1 hour
Show answer
The mixing instructions state to wait 5 to 10 minutes to allow the packets to thoroughly dissolve before turning on agitation.🔗 Source
According to the label, where is Dimension Ultra 40WP intended for application?
- Indoor residential carpets
- Outdoor sites such as lawns, golf courses, and ornamentals
- Indoor greenhouse environments only
- Only inside commercial sod farms
Show answer
The label specifies outdoor applications including established lawns, golf course fairways, and ornamentals.🔗 Source
← All practice exams