Start practice — 8 questions →
Sample questions
According to the label, what is a major restriction regarding the use of this product for termite management?
- It cannot be used on wood containing termites.
- It is only for outdoor termite control.
- It is not intended as a substitute for termite control.
- It must be used at a 0.5% emulsion for termites.
Show answer
The label explicitly states: 'This treatment is not intended as a substitute for termite control.'🔗 Source
When treating under slabs via drilling and injecting per 10 sq ft, what is the required dilution?
- 0.1% emulsion
- 0.25%-0.5% emulsion
- 1.0% emulsion
- 0.65% emulsion
Show answer
The label specifies a 0.25%-0.5% emulsion for under slab applications per 10 sq ft.🔗 Source
When applying Demon Max to residential lawns, what is the maximum allowable height of the lawn at the time of application?
- 1 inch
- 2 inches
- 3 inches
- 4 inches
Show answer
The label states the lawn should not be longer than 3 inches at the time of application.🔗 Source
In which state is Demon Max not approved for use?
- Texas
- Florida
- California
- Arizona
Show answer
The label states 'Not approved for use in California' under the ant mound treatment section.🔗 Source
When treating tree trunks or building siding for Boxelder Bugs, how should the product be applied?
- Thoroughly, but not to the point of runoff
- Until the surface is dripping wet
- Only on the shaded side of the trunk
- In a 2 ft diameter circle only
Show answer
The label instructs to spray tree trunks or siding thoroughly, but not to the point of runoff.🔗 Source
For best results when applying to lawns, when is the recommended time of day to apply the product?
- In the heat of the day
- At high noon
- In early morning or late evening hours
- Only during midday
Show answer
The label recommends applying in cool weather, such as early morning or late evening, but not in the heat of the day.🔗 Source
If a technician is treating an ant mound larger than 12 inches, what adjustment may be needed?
- Use a 0.5% emulsion instead of 0.1%
- A higher volume and wider treatment diameter up to 4 ft
- Apply only to the center of the mound
- Use a rate of 0.33 fl oz per 1,000 sq ft
Show answer
For mounds larger than 12 inches, the label notes a higher volume and wider treatment diameter (up to 4 ft) may be needed.🔗 Source
Which of the following pests is specifically listed as a target for Demon Max when treating ant mounds?
- Termites
- Fire Ants
- Chinch bugs
- Boxelder Bugs
Show answer
The label specifically lists Ants, Ant Mounds, and Fire Ants as targets for mound treatments.🔗 Source
← All practice exams