Start practice — 16 questions →
Sample questions (showing 8 of 16)
What is the required application rate for Rabbitbrush when treating Big Sagebrush and Rabbitbrush?
- 2-1/4 pints per acre
- 3 quarts per acre
- 6-3/4 pints per acre
- 4 pints per acre
Show answer
For Big Sagebrush and Rabbitbrush, the label states the 6-3/4 pints rate is usually required for rabbitbrush.🔗 Source
Which of the following is a specific restriction regarding the use of Cy Kick CS?
- Do not use this product with oil
- Do not use this product near ornamental plants
- Do not use this product on porches or patios
- Do not use this product in garages
Show answer
The label explicitly states 'RESTRICTIONS: DO NOT use this product with oil.'🔗 Source
For Tree Injections (Pine Release) targeting hardwoods like Oak, Hickory, or Maple, what is the recommended spacing for injections?
- 1 to 1-1/2 inches apart edge to edge
- 2 inches apart edge to edge
- 5 inches apart edge to edge
- Injections should be made once per tree
Show answer
For hardwoods in tree injections, the label instructs to space injections 2 inches apart edge to edge.🔗 Source
When applying to Northern conifers, Jack Pine, Red Pine, Black Spruce, and White Spruce to control hardwoods, when should the application occur?
- In the spring during flower head emergence
- After the conifers cease growth and 'harden off' (usually mid-July)
- Between May 15 and June 15
- While pine buds are still dormant
Show answer
The label states to apply by air after these specific conifers cease growth and 'harden off', usually in mid-July.🔗 Source
To release Douglas fir, hemlock, Sitka spruce or grand fir, what is the correct application rate and timing?
- 3 quarts per acre before new growth on Douglas fir is 2 inches long
- 1-1/2 to 2 quarts per acre when 3/4 of foliage has full size leaves
- 2 quarts per acre while pine buds are still dormant
- 3 quarts per acre before pine growth begins in the Spring
Show answer
The label states to apply 3 quarts of product per acre before new growth on Douglas fir is 2 inches long to release these species.🔗 Source
To avoid a shock hazard, where should you NOT use water-based sprays of Cy Kick CS?
- On ornamental plants
- On window frames and eaves
- In conduits, motor housings, or junction boxes
- On porches and patios
Show answer
The label warns not to use water-based sprays in conduits, motor housings, junction boxes, switch boxes, or other electrical equipment due to shock hazard.🔗 Source
When preparing a Perimeter Barrier Application using 5 gallons of water, what is one of the listed possible amounts of Cy Kick CS to add?
- 0.1 fl. oz. (3 mL)
- 1 fl. oz. (30 mL)
- 10 fl. oz. (300 mL)
- 0.05 fl. oz. (1.5 mL)
Show answer
The mixing notes list 1 fl. oz. (30 mL) as a valid amount for 5 gallons of water for Perimeter Barrier Applications.🔗 Source
When using Cy Kick CS for termites, what is the intended purpose of the application?
- To serve as a complete substitute for soil treatment
- To provide sole protection against subterranean termites
- To kill workers or winged reproductive forms present in treated channels
- To perform mechanical alteration of the soil
Show answer
The label states the purpose for termites is to kill workers or winged reproductive forms present in treated channels and is merely a supplement.🔗 Source
← All practice exams