Start practice — 8 questions →
Sample questions
When applying Cutless Shrub and Tree Sculptor to landscape hedges, what factor determines the specific application rate within the 0.8 to 3.2 ounces per plant range?
- The type of spreader used for application
- The age of the plant
- The plant height
- The soil fertility of the area
Show answer
Rates depend on plant height; higher rates required for larger plants with greater woody mass🔗 Source
Under which condition should an applicator avoid applying Cutless Shrub and Tree Sculptor?
- During periods of high soil fertility
- When rainfall or irrigation is expected within 48 hours
- When applying to plants that are stressed or rapidly declining
- Both B and C
Show answer
Avoid application when rainfall or irrigation is expected to occur within 48 hours; DO NOT apply to plants that are stressed or rapidly declining due to moisture, temperature, low soil fertility, or chemical injury🔗 Source
What is the Re-entry Interval (REI) for this product?
- 24 hours
- 48 hours
- 12 hours
- 6 months
Show answer
REI: 12 hours🔗 Source
When applying Cutless Shrub and Tree Sculptor to single trees or shrubs, which method is permitted for smaller scale applications?
- Aerial application
- Chemigation system
- Gloved hand or pre-measured scoop
- Rotary-type spreader only
Show answer
For smaller scale applications or treatment to single trees or shrubs, applications may be made by gloved hand or pre-measured scoop🔗 Source
According to the label, what is the required Personal Protective Equipment (PPE) for applicators and other handlers of Cutless Shrub and Tree Sculptor?
- Long-sleeved shirt, long pants, shoes, socks, and protective eyewear
- Long-sleeved shirt, long pants, gloves, and chemical-resistant boots
- Long-sleeved shirt, long pants, gloves, and protective eyewear
- Long-sleeved shirt, long pants, shoes, and chemical-resistant gloves
Show answer
Applicators and other handlers must wear long-sleeved shirt and long pants, shoes plus socks, and protective eyewear.🔗 Source
For best results, when should the product be applied in relation to water availability?
- When no water is expected for 48 hours
- When rainfall is expected within a few days or sufficient irrigation is applied to move it into the root zone
- Only when applied via a chemigation system
- Immediately before a heavy rain event that may move granules from the target area
Show answer
For best results, apply when rainfall is expected within a few days of the application or apply sufficient irrigation to move this product into the root zone🔗 Source
What is the maximum amount of Cutless Shrub and Tree Sculptor that can be applied per acre per year?
- 3.2 ounces per plant
- 10 pounds per 1,000 ft²
- 26.7 lbs. of this product per acre
- 43,560 lbs. per acre
Show answer
The maximum number of annual applications is determined by the sum of the rates applied, not to exceed 26.7 lbs. of this product per acre🔗 Source
Which of the following is a strict restriction regarding the use of Cutless Shrub and Tree Sculptor?
- Do not apply to annual bedding plants or areas intended for annual bedding plants within 6 months of application unless potential growth regulation is acceptable
- Do not apply to plants that are undergoing terminal growth suppression
- Do not apply to plants with high woody mass
- Do not apply to plants in the root zone
Show answer
DO NOT apply to annual bedding plants or areas intended for annual bedding plants within 6 months of application unless potential growth regulation of those plants is acceptable🔗 Source
← All practice exams