Start practice — 8 questions →
Sample questions
Which group of pests is specifically targeted by the ULV Non-Thermal Aerosol (cold fog) application of CSI 4 4 2026 03 22?
- mosquitoes, midges and black flies
- flies and cockroaches
- mosquitoes and termites
- midges and ants
Show answer
The label states that ULV Non-Thermal Aerosol applications target mosquitoes, midges and black flies.🔗 Source
According to the label, where is the only location permitted for the use of CSI 4 4 2026 03 22?
- Outdoor
- Indoor
- Both Indoor and Outdoor
- Greenhouses only
Show answer
All application sites listed in the label facts (ULV, Thermal, Barrier, and Aerial) are designated as 'Outdoor'.🔗 Source
What is the maximum allowable rate for Barrier Applications of this product?
- 0.007 lbs. a.i./acre
- 0.001 lbs. a.i./acre
- 0.007 lbs. of synergist per acre
- 16.08 ounces per minute
Show answer
The label explicitly states 'Do not exceed 0.007 lbs. a.i./acre' for Barrier Applications.🔗 Source
When using a mist blower for Barrier Applications, what droplet volume median diameter should be used?
- 50 – 100µm
- 10 – 50µm
- 100 – 200µm
- 0.001 – 0.007µm
Show answer
The label instructs to use a mist blower adjusted to deliver droplets with a volume median diameter of 50 – 100µm for barrier applications.🔗 Source
For a ULV Non-Thermal Aerosol application using undiluted product, what is the required flow rate at an average vehicle speed of 10 mph?
- 2.28 to 16.08 ounces per minute
- 0.001 to 0.007 ounces per minute
- 1.0 to 2.0 ounces per minute
- 5.0 to 10.0 ounces per minute
Show answer
The label notes that if applying undiluted via ULV ground equipment at 10 mph, the flow rate should be 2.28 to 16.08 ounces per minute.🔗 Source
When performing an Aerial Application, what is the minimum required ground wind speed?
- equal to or greater than 1 mph
- exactly 5 mph
- at least 10 mph
- greater than 0 mph
Show answer
The label specifies to apply only when ground wind speed is equal to or greater than 1 mph for aerial applications.🔗 Source
In a ULV Non-Thermal Aerosol application, how should the product be diluted if not used undiluted?
- with a suitable solvent such as mineral oil
- with water only
- with a 1:1 ratio of alcohol
- with a 2 part surfactant
Show answer
The label states the product can be undiluted or diluted with a suitable solvent such as mineral oil.🔗 Source
What is the height restriction for fixed wing aircraft during an Aerial Application, unless specifically approved by the state or tribe?
- Not less than 100 feet
- Not less than 50 feet
- Not less than 75 feet
- Not less than 200 feet
Show answer
The label states do not apply by fixed wing aircraft at a height less than 100 feet unless specifically approved.🔗 Source
← All practice exams