Start practice — 8 questions →
Sample questions
To produce a 16 fl. oz. finished mix to treat 125 sq. ft., how much product is needed?
- 1.6 fl. oz.
- 3.2 fl. oz.
- 6.5 fl. oz.
- 13.0 fl. oz.
Show answer
The label states 1.6 fl. oz. of product with 14.4 fl. oz. of water produces 16 fl. oz. finished mix for 125 sq. ft.🔗 Source
According to the label, what is the specific target pest for CrossFire Aerosol?
- Bed Bugs
- Cockroaches
- Ants
- Fleas
Show answer
The label facts explicitly list Bed Bugs as the target pest.🔗 Source
Which of the following is a specific use restriction for CrossFire Aerosol?
- Do not apply in, on or around electrical equipment due to shock hazard
- Do not apply in areas with high humidity
- Do not apply near open flames
- Do not apply in residential kitchens
Show answer
The restrictions section states not to apply around electrical equipment due to the possibility of shock hazard.🔗 Source
What Personal Protective Equipment (PPE) must applicators and handlers wear?
- Long-sleeved shirt, long pants, and shoes and socks
- Chemical resistant gloves and goggles
- N95 respirator and face shield
- Coveralls and rubber boots
Show answer
The PPE section requires a long-sleeved shirt, long pants, and shoes and socks.🔗 Source
When preparing a 1.0 gallon finished mix to treat 1,000 sq. ft., what is the required amount of CrossFire Aerosol and water?
- 13.0 fl. oz. product and 115.0 fl. oz. water
- 6.5 fl. oz. product and 57.5 fl. oz. water
- 19.5 fl. oz. product and 172.5 fl. oz. water
- 16.0 fl. oz. product and 128.0 fl. oz. water
Show answer
The label states that 13.0 fl. oz. of product with 115.0 fl. oz. of water produces 1.0 gal. finished mix for 1,000 sq. ft.🔗 Source
What is the required application method for treating Bed Bugs with this product?
- Apply as a coarse wet spray or spot treatment
- Apply as a fine mist only
- Apply as a dry powder dusting
- Apply as a heavy flood spray
Show answer
The label notes specify to apply as a coarse wet spray or spot treatment.🔗 Source
What is the finished strength of the Bed Bug dilution mixes listed in the label?
Show answer
All mixing instructions provided in the label specify a finished strength of 1.42%.🔗 Source
Based on the provided label facts, how much finished mix is required to treat 1,500 sq. ft.?
- 1.5 gal.
- 1.0 gal.
- 0.5 gal.
- 2.0 gal.
Show answer
The label specifies that 1.5 gal. of finished mix is used to treat 1,500 sq. ft.🔗 Source
← All practice exams