Start practice — 8 questions →
Sample questions
What equipment is strictly prohibited for loading or applying this product?
- Mop buckets
- Foaming applicators
- Pressurized equipment
- Handheld dusters
Show answer
The label states: 'Do not use pressurized equipment to load or apply the product.'🔗 Source
Where is the powder specifically prohibited from being applied?
- In sewers
- In transport vehicles
- Directly in electrical boxes
- In animal rearing areas
Show answer
The restrictions state 'powder should not be applied directly in electrical boxes.'🔗 Source
In a food handling establishment, how may BorActin be applied in the food area?
- As a mop solution on all floors
- As a liquid spray on food processing surfaces
- As a crack and crevice treatment only
- As a dust applied to all open surfaces
Show answer
The label states that applications in the food area of food handling establishments other than as a crack and crevice treatment are not permitted.🔗 Source
According to the PPE section, what should a technician do with contaminated clothing?
- Discard it immediately
- Remove and wash before reuse
- Air dry before wearing again
- Wash only after the next application
Show answer
The PPE instructions state to 'Remove contaminated clothing and wash before reuse.'🔗 Source
When applying BorActin as a dust, what is the recommended application rate?
- 1 lb per 1000 sq ft
- 1 cup per 1000 sq ft
- 1 gallon per 1000 sq ft
- 1 lb per gallon of water
Show answer
The label specifies a rate of 1 lb per 1000 sq ft when used as a dust.🔗 Source
To control drain flies using the mop solution method, how much solution should be poured into each floor drain?
- Up to 1 cup
- Up to 1 gallon
- Up to 1 quart
- Up to 1 lb
Show answer
The label notes that after mopping, up to a quart of mop solution can be poured into each floor drain to control drain flies.🔗 Source
Which of the following is a target pest for BorActin Insecticide Powder?
- Termites
- Darkling Beetles
- Bed Bugs
- Ants
Show answer
The label lists Darkling Beetles as one of the target pests.🔗 Source
When using BorActin as a liquid or foam, what is the maximum dilution rate?
- 1 cup per gallon of water
- 1 lb per 1000 sq ft
- Up to 1 lb per gallon of water
- 1 quart per gallon of water
Show answer
The label instructions for liquid or foam state to 'Mix up to 1 lb per gallon of water'.🔗 Source
← All practice exams