Start practice — 8 questions →
Sample questions
To achieve a 0.12% finished strength, how much product should be mixed with 49.75 gallons of water?
Show answer
The mixing instructions state that 1 qt. of product in 49.75 gallons of water results in a 0.12% finished strength.🔗 Source
When treating for termites in soil, the label notes that the 0.06% rate should only be used in conjunction with what?
- Pre-construction applications
- Injection techniques
- Volume adjustments, foam applications, or underground services applications
- A minimum of 2 quarts of product per 100 gallons
Show answer
The notes for soil termite treatment state to use that rate only in conjunction with volume adjustments, foam applications or underground services applications.🔗 Source
What is the required dilution concentration for pre- and postconstruction applications against subterranean termites?
Show answer
The label specifies a 0.12% dilution for pre- and postconstruction applications.🔗 Source
When treating soil for subterranean termites, what is the required application rate for a 0.06% dilution?
- 4 gallons of dilute dilution per 10 linear feet per foot of depth of the trench, or 1 gallon per 1.0 cubic feet of soil
- 0.5 gallons per 10 ft2 (horizontal) or 2.0 gallons per 10 linear ft. (vertical)
- 1 quart per 99.75 gallons of water
- 3.2 oz. per 4.975 gallons of water
Show answer
The label specifies 4 gallons of dilute dilution per 10 linear feet per foot of depth of the trench, or 1 gallon per 1.0 cubic feet of soil for soil treatments.🔗 Source
When performing pre- and postconstruction applications, what is the vertical application rate?
- 0.5 gallons per 10 ft2
- 1.0 gallon per 1.0 cubic feet
- 2.0 gallons per 10 linear ft.
- 4.0 gallons per 10 linear feet per foot of depth
Show answer
For pre- and postconstruction applications, the vertical rate is 2.0 gallons per 10 linear ft.🔗 Source
According to the label, how should subterranean termites in infested and/or damaged wood be treated?
- By spraying the surface of the wood with a 0.12% dilution
- By using an injection technique as described in the 'Control of Wood Infesting Insects' section
- By applying 0.5 gallons per 10 ft2 to the wood surface
- By mixing 1 quart with 99.75 gallons of water and soaking the wood
Show answer
The label states to treat infested/damaged wood in place using an injection technique described in the 'Control of Wood Infesting Insects' section.🔗 Source
For pre- and postconstruction applications using a 0.12% dilution, what is permitted regarding the volume?
- The volume may be doubled if the infestation is high
- The volume of the 0.12% dilution may be reduced by 1/2 the labeled volume where desirable
- The volume must be increased by 10 linear feet per foot of depth
- The volume cannot be adjusted under any circumstances
Show answer
The label states that for pre- and postconstruction applications, the volume of the 0.12% dilution may be reduced by 1/2 the labeled volume where desirable.🔗 Source
Which of the following is a stated restriction for using Bifen I T?
- Do not apply outdoors during rain
- Do not apply at a lower dosage and/or concentration than specified
- Do not apply to wood without an injection technique
- Do not apply more than 2 quarts per 100 gallons
Show answer
The label explicitly states: 'Do not apply at a lower dosage and/or concentration than specified'.🔗 Source
← All practice exams