Start practice — 8 questions →
Sample questions
Which of the following is a specific application restriction for Armada 50 WDG?
- Do not apply by aerial application
- Do not apply during daylight hours
- Do not apply to sports fields
- Do not apply if temperature is above 90 degrees
Show answer
The restrictions section explicitly states 'Do not apply by aerial application.'🔗 Source
Which of the following is a target pest for Armada 50 WDG?
- Dollar spot (Sclerotinia homoeocarpa)
- Aphids
- Armyworms
- Grubs
Show answer
Dollar spot is explicitly listed as a target pest in the application facts.🔗 Source
When creating a tank mixture, what is the correct order for adding partners according to the label?
- Liquids first, then wettable granules
- Emulsifiable concentrates first, then wettable powders
- Wettable granules (like Armada 50 WDG), then liquid flowables, then emulsifiable concentrates
- Any order is acceptable as long as the agitator is running
Show answer
The label specifies the order: (1) water soluble packaging/wettable powders/granules, (2) liquid flowables/liquids, and (3) emulsifiable concentrates.🔗 Source
To ensure the product reaches the crown and upper root zone for soil-borne diseases like summer patch, what should be done?
- Apply via aerial spray
- Irrigate immediately after application with sufficient water
- Mix with an organosilicate-based product
- Wait 24 hours before watering
Show answer
For soil-borne diseases, the notes state to use sufficient water to reach the crown/root zone or irrigate immediately after application.🔗 Source
In which location should Armada 50 WDG be applied?
- Indoor residential carpets
- Greenhouse interior soil
- Outdoor turf sites
- Indoor ornamental plants
Show answer
All listed applications for the product specify 'Outdoor' as the location.🔗 Source
According to the label, what is the recommended amount of water to use per 1,000 sq ft for thorough coverage?
- 0.5-1 gallon of water
- 1-2 gallons of water
- 2-4 gallons of water
- 5 gallons of water
Show answer
The label notes to apply the listed rate in 1-2 gallons of water per 1,000 sq ft to ensure thorough coverage.🔗 Source
When mixing Armada 50 WDG alone, what is the correct procedure for adding water?
- Fill the tank completely with water before adding product
- Add the prescribed dose, then add all water at once
- Add 1/2 of the required water, add product with agitator running, then add remainder of water
- Mix the product with a liquid flowable first, then add water
Show answer
The mixing instructions state to add 1/2 of the required water, add the dose with the agitator running, and then add the remainder of the water.🔗 Source
What is a required PPE precaution regarding treated areas?
- Wear a respirator for 48 hours after application
- Do not enter treated areas without protective clothing until sprays have dried
- Avoid contact with soil for 7 days
- Use gloves only when mixing, not when entering areas
Show answer
The PPE section states: 'Do not enter treated areas without protective clothing until sprays have dried.'🔗 Source
← All practice exams