Start practice — 8 questions →
Sample questions
According to the application instructions, what is the required application rate for AquaBac® 400G?
- 5 lbs per 5,000 sq. ft. of water surface
- 5 lbs per 1,000 sq. ft. of water surface
- 50 lbs per 5,000 sq. ft. of water surface
- 1 lb per 5,000 sq. ft. of water surface
Show answer
The label specifies an application rate of 5 lbs per 5,000 sq. ft. of water surface.🔗 Source
Which of the following pests is AquaBac® 400G specifically designed to control?
- Mosquito larvae
- Adult mosquitoes
- Mosquito adults and larvae
- All mosquito life stages
Show answer
The label states the product is effective against mosquito larvae but does not control adult mosquitoes.🔗 Source
What must be done regarding unprotected persons following application?
- Keep unprotected persons out of the treated areas until sprays have dried
- Keep unprotected persons away for 24 hours regardless of drying
- Ensure unprotected persons wear gloves only
- Unprotected persons may enter once the product is ingested by larvae
Show answer
The label restriction states to keep unprotected persons out of the treated areas until sprays have dried.🔗 Source
What is a specific restriction regarding the disposal of equipment washwaters?
- Do not contaminate water when disposing of equipment washwaters
- Only dispose of washwaters in catch basins
- Washwaters must be diluted by 50% before disposal
- Washwaters must be applied to salt marshes
Show answer
The restrictions section states: 'Do not contaminate water when disposing of equipment washwaters.'🔗 Source
If AquaBac® 400G comes into contact with the eyes, how long should you rinse the eyes with water?
- 15-20 minutes
- 5-10 minutes
- 30 minutes
- Immediately for 1 minute
Show answer
The PPE instructions state to rinse eyes slowly and gently with water for 15-20 minutes.🔗 Source
Which of the following is a listed site for application of AquaBac® 400G?
- Storm water retention areas
- Dry land residential lawns
- Indoor carpeted areas
- Fruit orchards
Show answer
Storm water retention areas are explicitly listed as a site for application.🔗 Source
In which of the following environments can AquaBac® 400G be applied?
- Both indoor and outdoor aquatic environments
- Outdoor water bodies only
- Indoor water sites only
- Only in salt marshes and tidal water
Show answer
The label specifies that it can be applied to both indoor and outdoor aquatic environments.🔗 Source
When treating catch basins, marshes, or mangrove waters, how long should a technician allow for control depending on water circulation or vegetation?
- 24 hours
- 12 hours
- 48 hours
- 1 hour
Show answer
The label notes to allow 24 hours for control under certain conditions such as catch basins, marshes, or mangrove waters.🔗 Source
← All practice exams