Start practice — 8 questions →
Sample questions
Which of the following pests is Altriset 2026 03 22 specifically labeled to control?
- Subterranean termites
- Ants and cockroaches
- Bed bugs
- Fleas and ticks
Show answer
The label facts list subterranean termites, drywood termites, and termites as target pests.🔗 Source
What is the purpose of using Altriset 2026 03 22 in a post-construction setting?
- Remedial control or preventive termite protection
- Only for localized drywood termite infestations
- To treat moisture problems in wood
- To eliminate direct wood-to-soil contact
Show answer
The label states that for post-construction, it can be used for remedial control or preventive termite protection.🔗 Source
To achieve maximum effectiveness against subterranean termites in structures, what must the technician do?
- Correct conducive conditions like moisture problems and direct wood-to-soil contact
- Apply the product at the highest possible concentration
- Apply the product only during dry weather
- Use the product only on non-structural items like firewood
Show answer
The label notes that Altriset may not be completely effective unless conducive conditions like moisture problems and direct wood-to-soil contact are corrected.🔗 Source
When treating structures for subterranean termites, what is the required dilution range?
- 0.05%-0.1%
- 0.1%-0.5%
- 1.0%-2.0%
- 0.01%-0.05%
Show answer
The label specifies a dilution of 0.05%-0.1% for subterranean termite applications in structures.🔗 Source
For a 50-gallon application, how much product is needed to reach a 0.1% finished strength?
- 34 fl oz or 2 pt 2 oz (1 L)
- 17 fl oz or 1 pt 1 oz (500 mL)
- 68 fl oz or 4 pt 4 oz (2 L)
- 34 fl oz or 2 pt 2 oz (1 L)
Show answer
The mixing table states that 34 fl oz or 2 pt 2 oz (1 L) per 50 gallons produces a 0.1% finished strength.🔗 Source
How much Altriset 2026 03 22 should be mixed with 1 gallon of water to achieve a finished strength of 0.1%?
- 0.68 fl oz (20 mL)
- 0.34 fl oz (10 mL)
- 1.0 fl oz (30 mL)
- 2.0 fl oz (60 mL)
Show answer
According to the mixing instructions, 0.68 fl oz (20 mL) per 1 gallon results in a 0.1% finished strength.🔗 Source
If a technician needs to prepare 100 gallons of a 0.05% solution, what amount of product is required?
- 34 fl oz (1 L)
- 68 fl oz (2 L)
- 17 fl oz (500 mL)
- 8.5 fl oz (250 mL)
Show answer
The mixing instructions specify 34 fl oz (1 L) per 100 gallons for a 0.05% finished strength.🔗 Source
Altriset 2026 03 22 can be used on non-structural sites. Which of the following is an example of a non-structural site listed?
- Posts, poles, trees, and firewood
- Building foundations
- Pre-construction soil
- Post-construction structures
Show answer
The label identifies non-structural sites as posts, poles, trees, and firewood.🔗 Source
← All practice exams