Start practice — 23 questions →
Sample questions (showing 8 of 23)
According to the label, at what stage of mosquito development is Altosid Briquets ineffective?
- Egg stage
- Early larval stage
- Pupal or adult stage
- Pre-hatch stage
Show answer
The restrictions state that the insect growth regulator has no effect on mosquitoes which have reached the pupal or adult stage prior to treatment.🔗 Source
When treating small containers that cannot be emptied (such as flower pots or old tires), what is the required application rate?
- 1 tsp. per gallon
- 1/2 cup per gallon
- 80 granules per gallon
- 1 tbls. per gallon
Show answer
For small containers that cannot be emptied or discarded, the rate is 80 granules per every gallon of water.🔗 Source
Under which wind speed condition is it prohibited to apply the product?
- When wind speed on the ground is < 1 phm and >= 10 phm
- When wind speed is exactly 5 phm
- When wind speed is above 20 phm
- When wind speed is below 1 phm
Show answer
The label states: 'Do not apply when wind speed on the ground is < 1 phm and >= 10 phm.'🔗 Source
Where should Altosid Briquets be placed within mosquito breeding sites to maintain continuous control as sites alternately flood and dry up?
- On the surface of the water
- In the shallowest edges of the site
- In the lowest areas of the breeding sites
- Floating near water hyacinth beds
Show answer
The label instructs to place briquets in the lowest areas of mosquito breeding sites to maintain continuous control.🔗 Source
Where should Altosid Briquets be applied according to the location descriptions?
- Indoor only
- Outdoor only
- Indoor and Outdoor
- Only in residential kitchens
Show answer
All application sites listed in the label facts are categorized under the 'Outdoor' location.🔗 Source
When treating cattail marshes and water hyacinth beds for Coquillettidia and Mansonia spp., what is the correct application rate?
- 1 briquet per 200 ft2
- 1 briquet per 100 ft2
- 1 briquet per catch basin
- 1 briquet per 2 feet of depth
Show answer
For Coquillettidia and Mansonia spp. in cattail marshes and water hyacinth beds, the rate is 1 briquet per 100 ft2.🔗 Source
Which of the following is a stated restriction regarding the disposal of unused product?
- Do not dispose of briquets in catch basins
- Do not dispose of product in areas deeper than two feet
- Do not contaminate water when disposing of unused product
- Do not dispose of product on snow or ice
Show answer
The restrictions section explicitly states: 'Do not contaminate water when disposing of unused product.'🔗 Source
When applying Altosid Briquets to terrestrial sites via aerial application, what is the minimum required dilution ratio with water?
Show answer
The label states that for aerial application to terrestrial sites, it must be diluted with water at a minimum of a 1:1 mix ratio.🔗 Source
← All practice exams