Start practice — 8 questions →
Sample questions
What risk is associated with using ALTACOR in tank mixtures that are not specifically described on the product label or in other FMC product use instructions?
- Reduced efficacy
- Potential crop injury
- Increased volatility
- Rapid degradation of the active ingredient
Show answer
The label states: 'Use of ALTACOR® in any tank mixture applications that is not specifically described on ALTACOR® product labeling or in other FMC product use instructions, could potentially result in crop injury.'🔗 Source
When mixing ALTACOR with other products, what is the primary restriction mentioned?
- Do not mix with products that contain a label prohibition against such mixing
- Do not mix with any liquid-based fertilizers
- Do not mix with products containing high concentrations of surfactants
- Do not mix with more than two other products at once
Show answer
The label states: 'This product cannot be mixed with any product containing a label prohibition against such mixing.'🔗 Source
Which statement is true regarding the storage of spray mix solutions prepared with ALTACOR?
- Solutions may be stored for up to 24 hours
- Solutions can be stored overnight if agitated
- Solutions should not be stored overnight in the spray tank
- Solutions must be stored in a cool, dark place overnight
Show answer
The label states: 'Do not store spray mix solutions overnight in spray tank.'🔗 Source
What is the guidance for selecting Personal Protective Equipment (PPE) when using ALTACOR in combination with other products?
- Use the PPE required for the most toxic product
- Use the PPE specifically listed for ALTACOR
- Use the most restrictive PPE of the products to be tested
- Use standard chemical-resistant gloves and goggles only
Show answer
The label states: 'PPE: Use the most restrictive PPE of the products to be tested.'🔗 Source
What is the required procedure for filling a spray tank when preparing an ALTACOR MIX?
- Fill the tank completely with water before adding the product
- Fill the tank 1/4 to 1/2 full of water before adding the product
- Fill the tank 1/2 to 3/4 full of water before adding the product
- Fill the tank with a concentrated solution first
Show answer
The label states: 'Fill spray tank 1/4 to 1/2 full of water. Add ALTACOR® directly to spray tank.'🔗 Source
According to the label, what method should be avoided when mixing the insecticide into the spray tank?
- Mechanical agitation
- Hydraulic agitation
- Air agitation
- Manual stirring
Show answer
The label states: 'Use mechanical or hydraulic means; do not use air agitation.'🔗 Source
In terms of dosage application, what does the label explicitly state?
- Do not exceed labeled dosage rates
- Always increase dosage by 10% if agitation is hydraulic
- Dilute only when applying to sensitive crops
- Use half dosage when mixing with non-FMC products
Show answer
The label states: 'Do not exceed labeled dosage rates.'🔗 Source
How should an applicator handle the spray mix solution once the insecticide has been fully dispersed?
- Allow it to sit undisturbed until application
- Use mechanical means to ensure continued agitation
- Stir manually every 30 minutes
- Add more water to prevent settling
Show answer
The label states: 'Mix thoroughly to fully disperse the insecticide; once dispersed continued agitation is required.'🔗 Source
← All practice exams