Start practice — 8 questions →
Sample questions
When performing a foliar spray application for the control of mites, what is the required application rate?
- 4 fl. oz. per 100 gals.
- 8 fl. oz. per 100 gals.
- 12 fl. oz. per 100 gals.
- 0.15 fl. oz. per 100 gals.
Show answer
According to the mixing and application rates, the rate for mites is 4 fl. oz. per 100 gals.Which of the following pests is Abamectin 0.15 Select specifically noted to suppress on ornamental plants?
- Aphids, whiteflies, and thrips
- European Red Mite and Tarsonemid mites
- Pine wilt nematode
- Leafminers
Show answer
The label states the product is designed for the control of leafminers and mites and the suppression of aphids, whiteflies, and thrips.Under which weather conditions should an applicator avoid applying Abamectin 0.15 Select?
- Wind speeds exceeding 15 mph
- Temperatures below 50 degrees
- High humidity levels
- Cloudy conditions without rain
Show answer
The timing/weather instructions state not to apply when wind speeds exceed 15 mph or during temperature inversions.What is the Re-entry Interval (REI) for this product?
- 12 hours
- 24 hours
- 48 hours
- 7 days
Show answer
The label facts specify a re-entry interval (rei_hours) of 12.Which of the following is a prohibited application method for this product?
- Application through any type of irrigation system
- Injection into trees and shrubs
- Foliar spray in greenhouses
- Injection for commercial forestry production
Show answer
The restrictions explicitly state: 'Do not apply through any type of irrigation system.'In which of the following settings is a foliar spray application of Abamectin 0.15 Select permitted?
- Interior and exterior landscapes
- Citrus nurseries
- Intertidal areas below mean high water mark
- Areas where surface water is present
Show answer
The label states foliar applications can be used in nurseries, greenhouses, and both interior and exterior landscapes, while explicitly prohibiting citrus nurseries and intertidal/surface water areas.To maintain control of leafminers during foliar applications, how often does the label recommend repeating applications?
- At 7-day intervals as necessary
- Every 24 hours
- Every 14 days
- Once per season
Show answer
The label recommends repeating foliar applications at 7-day intervals as necessary to maintain control of leafminers.According to the PPE requirements, what type of gloves are required for use with this product?
- Chemical-resistant gloves (EPA category B, e.g., barrier laminate or butyl rubber ≥ 14 mils)
- Disposable nitrile gloves
- Leather work gloves
- Cotton gloves
Show answer
The PPE section specifies chemical-resistant gloves (EPA category B, e.g., barrier laminate or butyl rubber ≥ 14 mils).← All practice exams